I’ve always just used a hammer… but for super rusty rotors, this works really well! 🔨

Where was this a week ago when I spent hours helping my neighbor with rotors that were seized on his truck??? 😑

he also used a metal plate between the bolt and the disk brake, pretty good trick

yall do know that little tiny hole that is on rotors is what this done i swear people come up with the dumbest shit and think they solved something that was ALREADY SOLVED for many years

Is it true that in the West, if you use tools instead of your bare fists to rip something open, people joke that you’re 'not a real man'?

One of the best ideas, I always use the jack bolt in the stud hole for stubborn hub bearings. 👍

Du kannt damit den Achsschenkel beschädigen 😂 es es wird teurer 😮

No co człowiek całe życie się uczy😂🎉

Id the rotors are being replaced, stop wasting time and use the baby sledge

Jego czapka jest już zmęczona takimi emocjami

Uu can also use a rubber or wooden hammer to hit the drums 🥁 without damaging it. 🥁 😂❤😅

And deny me the great release of getting to smack tf out of somthing with a hammer at work an not get in trouble for it... i think not

Жақсы екен 👍

👏👏👏👏✌️

*Jajaja* 😂😂😂

With my luck the hub breaks off

My discs were super sticky, only if i would have learned about this earlier.... 😢

Fantastic trick. Thanks.

If you can find a small enough bolt. I fully recommend the strategy!

Been doing that for years to get wheel bearings out

By the time you've done that on one corner, you could have knocked all four discs off with a hammer.